Passenger Door Module (PDM, DMFL/R)

B25AF-2A-DOOR LOCK/UNLOCK SWITCH-STUCK

For a complete wiring diagram, refer to the Wiring Information.





- When Monitored:
Continuously whenever the door module is awake.

- Set Condition:
When the Door Lock Switch Mux circuit is out of range for over five seconds.





Diagnostic Test

1. TEST FOR INTERMITTENT CONDITION
1. With the scan tool, record and erase the DTCs.
2. Operate the Passenger Door Lock Switch in all positions several times.
3. Turn the ignition on and wait 30 seconds.
4. With the scan tool, read the DTCs.

Does the scan tool display; B25AF-2A-DOOR LOCK/UNLOCK SWITCH - STUCK?

Yes

- Go To 2

No

- Test complete, the condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals and correct pin tension.
- Perform the BODY VERIFICATION TEST. Body Verification Test .

2. DOOR LOCK SWITCH
1.
2. Disconnect the Passenger Door Lock Switch harness connector.
3. Turn the ignition on.
4. Measure the voltage between the (G160) Passenger Door Lock Switch Mux circuit and the (Z911) Ground circuit.

Is the voltage above 4.5 Volts?

Yes

- Replace the Passenger Door Lock Switch. Power Lock Switch - Removal.
- Perform the BODY VERIFICATION TEST. Body Verification Test .

No

- Go To 3

3. (Z911) GROUND CIRCUIT OPEN
1.
2. Using a 12-volt test light connected to 12-volts, check the (Z911) Ground circuit.

Does the test light illuminate brightly?

Yes

- Go To 4

No

- Repair the open in the (Z912) Ground circuit.
- Perform the BODY VERIFICATION TEST. Body Verification Test .

4. (G160) PASSENGER DOOR LOCK SWITCH MUX CIRCUIT OPEN
1.
2. Turn the ignition off.
3. Disconnect the Passenger Door Module C5 harness connector.
4. Measure the resistance of the (G160) Passenger Door Lock Switch Mux circuit between the Door Module C5 harness connector and the Door Lock Switch connector.

Is the resistance below 2.0 Ohms?

Yes

- Go To 5

No

- Repair the open in the (G160) Passenger Door Lock Switch Mux circuit.
- Perform the BODY VERIFICATION TEST. Body Verification Test .

5. (G160) PASSENGER DOOR LOCK SWITCH MUX CIRCUIT SHORTED TO THE (Z911) GROUND CIRCUIT
1.
2. Measure the resistance between the (G160) Passenger Door Lock Switch Mux circuit and the (Z911) Ground circuit in the Door Lock Switch connector.

Is the resistance below 20K Ohms?

Yes

- Repair the (G160) Passenger Door Lock Switch Mux circuit for a short to the (Z911) Ground circuit.
- Perform the BODY VERIFICATION TEST. Body Verification Test .

No

- Replace the Passenger Door Module. Door Module - Removal.
- Perform the BODY VERIFICATION TEST. Body Verification Test .