C006A-62

C006A-62-MULTI-AXIS ACCELERATION SENSOR - SIGNAL COMPARE FAILURE

For a complete wiring diagram, refer to the Wiring Information.

- When Monitored:
When ignition is on and vehicle speed is above 15 km/h (9 mph).

- Set Conditions:
When the Anti-lock Brake System (ABS) Module detects that one of the three Dynamic Sensor signals does not agree with the calculated value.

NOTE: The Dynamics Sensor is internal to the Occupant Restraints Controller (ORC)






Diagnostic Test

1. VERIFY DTC IS ACTIVE
1. Turn the ignition on, engine not running.
2. With the scan tool, record and erase DTCs.

WARNING:
To avoid possible serious or fatal injury, check brake capability is available before road testing.

3. Test drive the vehicle by turning the vehicle left and right in a curving manner at a velocity between 15 and 35 km/h (9 and 22 mph).
4. Park the vehicle.
5. With the scan tool, read ABS DTCs.

Is this DTC active?

Yes

- Go To 2

No

- Perform the ABS-INTERMITTENT CONDITION TEST. ABS Intermittent Condition Test.

2. ANTI-LOCK BRAKE SYSTEM (ABS) MODULE
1. Replace the Occupant Restraints Controller (ORC). Occupant Restraint Controller - Removal.
2. Perform the ABS VERIFICATION TEST. ABS Verification Test.
3. Test drive the vehicle by turning the vehicle left and right in a curving manner at a velocity between 15 and 35 km/h (9 and 22 mph).
4. With the scan tool, read the DTCs.

Does the DTC remain still active?

Yes

- Replace the Anti-Lock Brake System (ABS) Module. Anti-Lock Brake System Module - Removal.
- Perform the ABS VERIFICATION TEST. ABS Verification Test.

No

- Test complete.