Radio

B222C-00-VEHICLE CONFIGURATION NOT PROGRAMMED-

For a complete wiring diagram, refer to the Wiring Information.

- When Monitored:
With the ignition on.

- Set Condition:
The radio detects that the vehicle configuration information not programmed into the BCM for greater than 5 seconds.





Diagnostic Test

1. TEST FOR AN INTERMITTENT CONDITION
1. Turn the ignition on.
2. Turn the ignition off, wait ten seconds then turn the ignition on.
3. With the scan tool, read DTCs.

Does the scan tool display: B222C-00-VEHICLE CONFIGURATION NOT PROGRAMMED-?

Yes

- Go To 2

No

- Test complete, the condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals and correct pin tension.
- Perform the BODY VERIFICATION TEST. Body Verification Test .

2. VERIFY COMMUNICATION WITH BCM
1. With the scan tool, read the active modules on the bus.

Does the scan tool show the BCM active on the bus?

Yes

- Go To 3

No

- Manufacturer Code Charts and perform the No Response From BCM diagnostic procedure.

3. CHECK BCM FOR ACTIVE DTCS
1. With the scan tool, erase BCM DTCs.
2. Turn the ignition off. Wait approximately ten seconds.
3. Turn the ignition on.
4. With the scan tool, read BCM DTCs.

Are any active DTCs present?

Yes

- Body Verification Test and perform the appropriate diagnostic procedure.

No

- Go To 4

4. CHECK THE VEHICLE CONFIGURATION INFORMATION WITH SCAN TOOL
1. With the scan tool run an ECU Details Report, read the Original and Current VINs, and the Body Style of the vehicle.

Does the information displayed match the vehicle?

Yes

- Replace the Body Control Module (BCM).
- Perform the BODY VERIFICATION TEST. Body Verification Test .

No

- Go To 5

5. RESTORE THE VEHICLE CONFIGURATION
1. With the scan tool, restore the vehicle configuration.
2. Turn the ignition off, then back on.
3. With the scan tool, read the active DTCs.

Does the scan tool display B222C-00-VEHICLE CONFIGURATION NOT PROGRAMMED- as active?

Yes

- Replace the Body Control Module (BCM).
- Perform the BODY VERIFICATION TEST. Body Verification Test .

No

- Test complete, the condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals and correct pin tension.
- Perform the BODY VERIFICATION TEST. Body Verification Test .