C153A-13

C153A-13-LEFT FRONT RIDE HEIGHT LEVEL CONTROL - CIRCUIT OPEN

For a complete wiring diagram, refer to the Wiring Information.





- When Monitored:
Ignition on. Battery voltage between 9 and 16 volts.

- Set Condition:
When the Air Suspension Control Module (ASCM) detects the Left Front Air Spring Valve Control circuit is open while ignition is in the Run position.





Diagnostic Test

1. DTC IS ACTIVE
1. Turn the ignition on.
2. With the scan tool, record and erase DTCs.
3. With the scan tool, read the DTCs in the ASCM.

Is the DTC status Active at this time?

Yes

- Go To 2

No

- Go To 6

2. AIR SUSPENSION SOLENOID ASSEMBLY HARNESS CONNECTOR

NOTE: Make sure the Air Suspension Solenoid Assembly harness connector is connected correctly.

1. Turn the ignition off.
2. Inspect the Air Suspension Solenoid Assembly harness connector for signs of water intrusion, corrosion, pushed out or bent terminals, and correct pin tension.

Were any problems found?

Yes

- Repair as necessary.
- Perform the ASCM VERIFICATION TEST. ASCM Verification Test.

No

- Go To 3

3. (Y30) AIR SPRING VALVE SUPPLY CIRCUIT OPEN OR HIGH RESISTANCE




1. Disconnect the Air Suspension Solenoid Assembly harness connector.
2. Disconnect the ASCM C2 harness connector
3. Measure the resistance of the (Y30) 12V Valve Power Supply circuit between the ASCM C2 harness connector and the Air Suspension Solenoid Assembly harness connector.

Is the resistance above 5.0 Ohms?

Yes

- Repair the (Y30) 12V Valve Power Supply circuit for an open or high resistance.
- Perform the ASCM VERIFICATION TEST. ASCM Verification Test.

No

- Go To 4

4. (Y32) LF AIR SPRING VALVE CONTROL CIRCUIT OPEN OR HIGH RESISTANCE




1. Measure the resistance of the (Y32) LF Air Spring Valve Control circuit between the ASCM C2 harness connector and the Air Suspension Solenoid Assembly harness connector.

Is the resistance above 5.0 Ohms?

Yes

- Repair the (Y32) LF Air Spring Valve Control circuit for an open or high resistance.
- Perform the ASCM VERIFICATION TEST. ASCM Verification Test.

No

- Go To 5

5. AIR SUSPENSION SOLENOID ASSEMBLY
1. Connect the Air Suspension Solenoid Assembly harness connector.
2. While back probing, measure the resistance between the (Y30) 12V Valve Power Supply circuit and the (Y32) LF Air Spring Valve Control circuit at the Air Suspension Solenoid Assembly.

Is the resistance above 30 Ohms?

Yes

- Replace the Air Suspension Solenoid Assembly. Compressor Assembly Valve Block - Removal.
- Perform the ASCM VERIFICATION TEST. ASCM Verification Test.

No

- Replace the Air Suspension Control Module (ASCM). Air Suspension Control Module - Removal.
- Perform the ASCM VERIFICATION TEST. ASCM Verification Test.

6. INTERMITTENT WIRING AND CONNECTORS
1. Using the wiring diagram/schematic as a guide, inspect the wiring harness and connectors.
2. Wiggle test the wiring harness and connectors while monitoring the scan tool data relative to this circuit.
3. Look for the data to change or for the DTC to reset during the wiggle test.
4. While monitoring the scan tool data relative to this circuit, move the selector switch to each position several times.
5. Look for the data to change other than as expected or for the DTC to reset.

Were any problems found?

Yes

- Repair as necessary.
- Perform the ASCM VERIFICATION TEST. ASCM Verification Test.

No

- Test complete, the condition or conditions that originally set this DTC are not present at this time.