Radiator Closure Panel - Installation

INSTALLATION






1. Carefully position the closure assembly (1) up onto the front end sheet metal mounting (3) and avoid damaging the front edges of the fenders.

2. Install the lower bolts (4) and tighten to 20 Nm (15 ft. lbs.)

3. Install the upper bolts (2) and tighten to 20 Nm (15 ft. lbs.)

4. Install the ground cables and install the bolts if necessary.

5. Install the fender support bolt from inside the wheelhouse splash shield.

6. Install the trim pieces below the headlights, if equipped.

7. Connect the PDC electrical connectors and position the PDC back into place.

8. Position the radiator back and insert the lower radiator mounts.

9. Install the upper radiator bolts.





10. Install the foam (1) and seat the push pin fasteners (2) fully.

11. Install the air cleaner assembly.

12. Install the headlamps.

13. Install the A/C condenser, if equipped. A/C Condenser - Installation

14. Install the front bumper. Front Bumper - Installation

15. Install the hood latch. Hood Latch - Installation

16. Install the coolant bottle, if necessary. Coolant Recovery Bottle - Installation

17. Install the washer bottle, if necessary.

18. Install the grille. Grille - Installation