A/C And Heater Control - Installation

INSTALLATION






NOTE:
Typical A/C-heater control shown.

1. Position the A/C-heater control (2) onto the back of the instrument panel center bezel (1).

2. Install the four screws (3) that secure the A/C-heater control to the center bezel. Tighten the screws to 2.2 Nm (20 in. lbs.).

3. Connect the wire harness connectors (4 and 5) to the back of the A/C-heater control and install the instrument panel center bezel Instrument Panel Center Bezel - Installation.

4. Reconnect the negative battery cable.

5. Initiate the Actuator Calibration function using a scan tool .