Front Lamp Unit Bulb - Installation

BULB - HEADLAMP

DUAL HEADLAMPS

CAUTION:
Always use the correct bulb size and type for replacement. An incorrect bulb size or type may overheat and cause damage to the lamp, the socket or the lamp wiring.

CAUTION:
Do not contaminate the bulb glass by touching it with your fingers or by allowing it to contact other oily surfaces. Shortened bulb life will result.




Figure 1 - Dual Headlamps

1. Align the headlamp bulb (3) with the keyed opening in the front lamp unit (1) reflector through the opening on the back of the lamp housing.

2. Insert the bulb into the keyed opening in the reflector until it is firmly seated.

3. Rotate the bulb clockwise about 30 degrees to lock it into place.

4. Reinstall the front lamp unit onto the vehicle. Front Lamp Unit - Installation.

QUAD HEADLAMPS

CAUTION:
Always use the correct bulb size and type for replacement. An incorrect bulb size or type may overheat and cause damage to the lamp, the socket or the lamp wiring.

CAUTION:
Do not contaminate the bulb glass by touching it with your fingers or by allowing it to contact other oily surfaces. Shortened bulb life will result.




Figure 2 - Quad Headlamps

NOTE:
There are access covers (6) installed over both headlamp bulb access holes in the quad front lamp unit housing. The illustration shows the cover for the low beam bulb removed for reference; however, both covers MUST be reinstalled prior to returning the vehicle to service.

1. Position the headlamp bulb (5) close enough to the appropriate low beam (upper) or high beam (lower) opening of the front lamp unit housing (1) to access and reconnect the front lamp unit pigtail wire harness connector to the bulb connector receptacle.

2. Align the headlamp bulb with the appropriate low beam (upper) or high beam (lower) keyed opening in the front lamp unit reflector.

3. Insert the bulb into the reflector until it is firmly seated.

4. Rotate the bulb clockwise about 30 degrees to lock it into place.

5. Align the access cover (6) with the appropriate low beam (upper) or high beam (lower) opening in the front lamp unit housing.

6. Insert the access cover into the housing until it is firmly seated.

7. Rotate the access cover clockwise to lock it into place.

8. Reinstall the front lamp unit onto the vehicle. Front Lamp Unit - Installation.