Pressure Air Line

PRESSURE AIR LINE

WARNING:
All pressurized air suspension components contain high pressure air (up to 220 psig). Use extreme caution when inspecting for leaks. Wear safety goggles and adequate protective clothing when inspecting or servicing the air suspension system. A sudden release of air under this amount of pressure can cause possible serious or fatal injury.

WARNING:
Support the vehicle by supplemental means before performing any work on the air suspension system to prevent the vehicle from changing height. Before any given component is to be serviced it must be deflated. Servicing the air suspension system without supplemental support, or with pressure in the specific component, can cause possible serious or fatal injury.

CAUTION:
When removing an air line from a component and the air line is to be reused, do not remove the 90° fitting or the brass fitting from the air line. If either is removed, the air line must be replaced. New components have air line fittings attached; however if the original air line is used the original fitting must also be used. Do not remove protective caps or plugs from air lines or components until ready to install the air line to prevent moisture or dirt intrusion. All air line fittings must be hand started to avoid cross threading.

1. Raise and support the vehicle Service and Repair.

2. Remove the RR tire and wheel .

3. Remove the RR wheel inner wheel liner.





4. Remove the Air Supply Compressor stone shield.





5. Remove the pressure air line/fitting (2) from the back of the compressor.





6. Remove the pressure air line/fitting (1) from the face of the valve block and remove the pressure air line from the vehicle.