Air Suspension Hose Assembly - Installation

INSTALLATION

WARNING:
All pressurized air suspension components contain high pressure air (up to 220 psig). Use extreme caution when inspecting for leaks. Wear safety goggles and adequate protective clothing when inspecting or servicing the air suspension system. A sudden release of air under this amount of pressure can cause possible serious or fatal injury.

WARNING:
Support the vehicle by supplemental means before performing any work on the air suspension system to prevent the vehicle from changing height. Before any given component is to be serviced it must be deflated. Servicing the air suspension system without supplemental support, or with pressure in the specific component, can cause possible serious or fatal injury.

1. Position the air suspension hose assembly in the vehicle.





2. Raise and support the vehicle Service and Repair

3. Connect the hose assembly (1, 2) to the quick disconnects.

4. Attach the hose assembly routing to the clips.

NOTE:
Before and while connecting the retaining clips , verify there is no twists or kinks in the hoses.

5. Remove the support and lower the vehicle.





6. Connect the filter (1) to the retaining clip (3) on the body.

7. Install the right tail lamp assembly.