Air Suspension Temperature Sensor - Removal

REMOVAL

WARNING:
All pressurized air suspension components contain high pressure air (up to 220 psig). Use extreme caution when inspecting for leaks. Wear safety goggles and adequate protective clothing when inspecting or servicing the air suspension system. A sudden release of air under this amount of pressure can cause possible serious or fatal injury.

WARNING:
Support the vehicle by supplemental means before performing any work on the air suspension system to prevent the vehicle from changing height. Before any given component is to be serviced it must be deflated. Servicing the air suspension system without supplemental support, or with pressure in the specific component, can cause possible serious or fatal injury.





NOTE:

1. Raise and support the vehicle Service and Repair.

2. Remove the RR tire and wheel .

3. Remove the RR wheel inner liner.





4. Remove the Air Suspension Compressor stone shield.





5. Disconnect the air suspension temperature sensor wiring harness electrical connector (4) and using a clock-wise motion remove connector clip (3) from ASU bracket.

6. Remove the air suspension temperature sensor retaining screw (1) and remove the sensor (2).