D.Body Wiring Harness Pn 4362293

FIGURE 3C - BODY WIRING:

FIGURE 3-F - BODY WIRING:

1. Vehicles With 36 Gallon Tank

Route harness, PN 4362293, to the right (passenger) side of vehicle along the fuel line tubes and tie wrap (1). At right frame rail, route harness forward to next crossmember (Figures 3-C and 3-E). Tie wrap harness in three (3) places.

FIGURE 3D - BODY WIRING:

FIGURE 3-F - BODY WIRING:

Vehicles With 22 Gallon Tank

Route harness, PN 4362293, along right frame rail following brake lines (Figures 3-D and 3-E). Tie wrap in two (2) places.
NOTE: HARNESS MUST BE ABOVE SHOCK STRUT WITH EITHER 36 OR 22 GALLON TANK.

2. At crossmember, route harness to the left rail following existing brake lines and tie wrap in two (2) places. At left rail, route harness forward through access holes following existing brake lines.

FIGURE 3-F - BODY WIRING:

NOTE: HARNESS SHOULD BE TIGHT IN THIS AREA THE WRAP IN FOUR
(4) PLACES (FIGURE 3-E).

3. At engine compartment, route harness through existing speedometer cable clips to bulkhead connector. If excess wiring exists; loop, tie wrap (2), and install into existing clip (Figure 3-F).

FIGURE 1D - TERMINAL END OF BULKHEAD CONNECTOR (ENGINE COMPARTMENT SIDE):

4. Plug bare terminal of harness, PN 4362293, into cavity #13 of the bulkhead connector (Figure 1-D).

FIGURE 7 - ELECTRIC FUEL PUMP WIRING DIAGRAM:

FIGURE 8 - ELECTRIC FUEL PUMP WIRING DIAGRAM W/AUX. A/C & HEATER AND POWER WINDOWS:

FIGURE 9 - ELECTRIC FUEL PUMP WIRING DIAGRAMW/AUX A/C & HEATER-W/O POWER WINDOWS:

5. For all vehicles except those which require a 78 amp alternator package:

Reinstall instrument panel side, then engine compartment side of bulkhead connector and torque bolt to 40 inch pounds.

NOTE: REFER TO FIGURES 7, 8, OR 9 FOR OVERALL WIRING DIAGRAMS.