D. Install the Liftgate Trim Panel

1. Position the trim panel on the liftgate and engage the frog-leg clips around the perimeter of the panel.





2. Install the six screws along the top and upper sides of the trim panel (Figure 5).

Caution:
DO NOT over tighten screws as this could damage trim panel or strip screws.

3. Install the two screws located in the speaker grille openings (Figure 5).

4. 1994 and 1995 MV only: Install the two screws and plugs in the center of the trim panel.

5. Install the two screws and plugs in the lower trim panel corners (Figure 5).

6. Install the assist handle with the two screws (Figure 5). Install the handle screw plugs.

7. Connect the courtesy lamp electrical connector and install the speaker grille/courtesy lamp assemblies.

8. Close the liftgate and verify that the latch and solenoid (if equipped) operate properly.