Extension Housing, Control Lever and Converter Installation

1. Install throttle valve and transmission shift levers on manual valve shaft. Tighten lever clamp screws securely.
2. Position new extension housing gasket on transmission case. Use petroleum jelly to hold gasket in place.
3. Install new rear seal in extension housing if required.
4. Install extension housing on transmission case. Tighten housing fasteners to 33 Nm (24 ft. lbs.). Be sure park lock rod is properly engaged in sprag beforehand.
5. Lubricate converter hub with transmission fluid and carefully install converter. Turn converter back and forth until seated.
6. Secure converter in oil pump before mounting transmission on jack and before moving transmission back under vehicle. Use metal strapping, C-clamp, or locking pliers to hold converter in place. Attach holding tool to converter housing.