Gearshift Linkage Adjustment

GENERAL INFORMATION
Check linkage adjustment by starting engine in Park and Neutral. Adjustment is acceptable if the engine starts in only these two positions. Adjustment is incorrect if the engine starts in one position but not both positions

If the engine starts in any other position, or if the engine will not start in any position, the park/neutral switch is probably faulty.

LINKAGE ADJUSTMENT

Linkage Adjustment Components:

Check condition of the shift linkage. Do not attempt adjustment if any component is loose, worn, or bent. Replace any suspect components.

Replace the grommet securing the shift rod or torque rod in place if either rod was removed from the grommet. Remove the old grommet as necessary and use suitable pliers to install the new grommet.
1. Shift transmission into Park.
2. Raise and support vehicle.
3. Loosen lock bolt in front shift rod adjusting swivel.
4. Ensure that the shift rod slides freely in the swivel. Lube rod and swivel as necessary.
5. Move transmission shift lever fully rearward to the Park detent.
6. Center adjusting swivel on shift rod.
7. Tighten swivel lock bolt to 10 Nm (90 inch lbs.).
8. Lower vehicle and verify proper adjustment.