Instrument Panel Cup Holder Replacement

INSTRUMENT PANEL CUP HOLDER
Vehicles equipped with an automatic transmission have a lighted fold-down cup holder installed on the instrument panel just inboard of the glove box. Vehicles equipped with a manual transmission have a lighted storage bin installed on the instrument panel in place of the fold-down cup holder.

WARNING: ON VEHICLES EQUIPPED WITH AIRBAGS, REFER TO AIRBAGS AND SEAT BELTS/AIRBAGS BEFORE ATTEMPTING ANY STEERING WHEEL, STEERING COLUMN, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR SERVICE. FAILURE TO TAKE THE PROPER PRECAUTIONS COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT AND POSSIBLE PERSONAL INJURY.

REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove the cluster bezel from the instrument panel. Refer to Cluster Bezel in the Removal and Installation for the procedures. Instrument Cluster Bezel Replacement
3. Unlatch and fold the cup holder down from the instrument panel to its open position.

Instrument Panel Cup Holder Remove/Install - Automatic Transmission Only:

4. Remove the six screws that secure the cup holder to the instrument panel.
5. Pull the cup holder away from the instrument panel far enough to access the illumination lamp and hood unit.
6. Disengage the illumination lamp and hood retainer clip from the back of the instrument panel cup holder unit.
7. Remove the cup holder unit from the instrument panel.

INSTALLATION
1. Position the cup holder unit to the instrument panel.
2. Engage the illumination lamp and hood retainer clip to the back of the instrument panel cup holder unit.
3. Position the cup holder unit onto the instrument panel.
4. Install and tighten the six screws that secure the cup holder to the instrument panel. Tighten the screws to 2.2 Nm (20 in. lbs.).
5. Install the cluster bezel onto the instrument panel. Refer to Cluster Bezel in the Removal and Installation for the procedures. Instrument Cluster Bezel Replacement
6. Reconnect the battery negative cable.