Rear Identification (ID) Lamps Replacement

REMOVAL
Individual lamps may be replaced by removing the lamp from the light bar. Using a flat blade screwdriver, carefully pry lamp to disengage clips attaching ID lamp to retainer.

Rear Identification Lamps:

1. Remove four screws attaching rear ID lamps to tailgate.
2. Separate ID lamps from tailgate.
3. Disengage ID lamp wire connector from body wire harness.
4. Separate ID lamp from vehicle.

INSTALLATION
1. Position ID lamp on vehicle.
2. Engage ID lamp wire connector to body wire harness.
3. Install screws attaching rear ID lamps to tailgate.