Linkage Adjustment

Fig. 312:

Check condition of the shift linkage (Fig. 312). Do not attempt adjustment if any component is loose, worn, or bent. Replace any suspect components.

Replace the grommet securing the shift rod or torque rod in place if either rod was removed from the grommet. Remove the old grommet as necessary and use suitable pliers to install the new grommet.
1. Shift transmission into Park.
2. Raise and support vehicle.
3. Loosen lock bolt in front shift rod adjusting swivel (Fig. 312).
4. Ensure that the shift rod slides freely in the swivel. Lube rod and swivel as necessary.
5. Move transmission shift lever fully rearward to the Park detent.
6. Center adjusting swivel on shift rod.
7. Tighten swivel lock bolt to 10 Nm (90 inch lbs.).
8. Lower vehicle and verify proper adjustment.