Wheel Hub: Service and Repair
HUB/BEARING - 4X2REMOVAL
1. Raise and support the vehicle.
2. Remove the wheel and tire assembly.
3. Remove the brake caliper and rotor.
4. Remove the ABS wheel speed sensor if equipped (4).
5. Remove the three hub/bearing mounting bolts (5) from the steering knuckle (3).
6. Slide the hub/bearing (1) out of the steering knuckle (3).
NOTE: The next step excludes SAT-10. (SAT-10 does not have a dust shield)
7. Remove the brake dust shield (2).
INSTALLATION
1. Install the brake dust shield (2). SRT-10 Excluded in this step.
2. Install the hub/bearing (1) into the steering knuckle (3) and tighten the bolts (5) to 163 Nm (120 ft. lbs.) 4X2 LD. Or tighten the bolts (5) to 176 Nm (130 ft. lbs.) 4X2 HD..
3. Install the brake rotor and caliper.
4. Install the ABS wheel speed sensor if equipped (4).
5. Install the wheel and tire assembly.
6. Remove the support and lower vehicle.