PCI Bus Internal Failure
PCI BUS INTERNAL FAILUREWHEN MONITORED
Continuously.
SET CONDITION
The Instrument Cluster fails the loopback test on the PCI Bus.
POSSIBLE CAUSES
- Instrument cluster
DIAGNOSTIC TEST
1. INSTRUMENT CLUSTER
NOTE: If this is an active DTC, answer yes to the question.
With the DRBIII(R), erase DTCs.
Cycle the ignition and wait approximately 1 minute.
With the DRBIII(R), read DTCs.
Q: Did this DTC reset?
YES: Replace the Instrument Cluster. Perform BODY VERIFICATION TEST - VER 1. Body Verification Test
NO: Test Complete.