Heated Mirror Relay: Service and Repair

NOTE: Refer to the fuse and relay layout map on the inside of the IPM cover for heated mirror relay location.

REMOVAL




1. Disconnect and isolate the negative battery cable (1).
2. Remove the cover from the integrated power module (IPM) (2) located in the engine compartment.
3. Remove the heated mirror relay from the IPM.

INSTALLATION




1. Position the heated mirror relay into the proper receptacle of the integrated power module (IPM) (2).
2. Align the heated mirror relay terminals with the terminal cavities in the IPM receptacle and push down firmly on the relay until the terminals are fully seated.
3. Install the cover onto the IPM.
4. Reconnect the negative battery cable (1).