B220E

B220E-ORC ROLL-OVER ACCELEROMETER

- When Monitored:

With the ignition on. The module's on board diagnostics continuously performs internal circuit tests.

- Set Condition:

This DTC will set if the module identifies an out of range Accelerometer Sensor.





Diagnostic Test

1. REPLACE OCCUPANT RESTRAINT CONTROLLER

Turn the ignition on.

WARNING: To avoid personal injury or death, turn the ignition off, disconnect the battery and wait two minutes before proceeding.

WARNING: If the Occupant Restraint Controller is dropped at any time, it must be replaced. Failure to take proper precautions could result in accidental airbag deployment and personal injury or death.

When this code is set, view repair.

Repair

- Replace the Occupant Restraint Controller.
- Perform the *AIRBAG SYSTEM VERIFICATION TEST - VER 1. Airbag System Verification Test