Diagnostic CAN C (+) Circuit Open

*DIAGNOSTIC CAN C (+) CIRCUIT OPEN





For a complete wiring diagram refer to Diagrams/Electrical.

- When Monitored:

When the scan tool queries the TIPM.

- Set Condition:

The scan tool has detected an open condition on the (D72) Diagnostic CAN C (+) circuit.





Diagnostic Test

1. CHECK THE STATUS OF THE ERROR MESSAGE

NOTE: Ensure the vehicle being tested is a CAN BUS VEHICLE. If not, false error messages may be displayed.

NOTE: Ensure the scan tool is updated to the latest software.

With the scan tool, record the error message.

Disconnect the scan tool from the DLC.

Cycle the ignition from on to off 3 times.

Turn the ignition on.

Does the scan tool display this same error message?

Yes

- Go To 2

No

- The conditions that caused this error message to set are not present at this time. Using the wiring diagram/schematic as a guide, inspect the wiring and connectors.

2. (D72) DIAGNOSTIC CAN C (+) CIRCUIT OPEN





Turn the ignition off.

Disconnect the TIPM C7 harness connector.

Disconnect the scan tool from the DLC.

Measure the resistance of the (D72) Diagnostic CAN C (+) circuit between the TIPM C7 harness connector and the DLC.

Is the resistance below 5.0 ohms?

Yes

- Inspect the wiring and connectors for damage or shorted circuits. If ok, replace the Totally Integrated Power Module.
- Perform the BODY VERIFICATION TEST - VER 1. Body Verification Test

No

- Repair the (D72) Diagnostic CAN C (+) circuit for an open.
- Perform the BODY VERIFICATION TEST - VER 1. Body Verification Test