Installation

INSTALLATION

The ignition key must be in the key cylinder for cylinder installation. The key cylinder must be removed first before installing ignition switch.





1. Before installing ignition switch (1), rotate the slot in the switch to the ON position.
2. Position switch (1) to column and install the mounting screws (2). Tighten screw to 3 Nm (26 in. lbs.).
3. Connect the electrical connector to rear of the ignition switch (4). Make sure that locking tabs are fully seated into wiring connector.




4. Install the tilt lever release bracket mounting screws. Tighten screws to 4.5 Nm (40 in. lbs.).
5. Install the key cylinder.
6. Install steering column upper and lower shrouds.
7. Install the steering column reinforcement and kneeblocker.
8. Enable the airbag system.