Engine - Installation

ENGINE





1. Position the engine in the vehicle.
2. Install the transmission bellhousing to engine mounting bolts (3). Tighten the bolts to 41 Nm (30ft. lbs.)
3. Install the engine mount thru bolts.




4. Install the torque convertor bolts (3).




5. Install the starter (4).
6. Connect the crankshaft position sensor.
7. Install the engine block heater power cable, if equipped.




CAUTION: The structural cover requires a specific torque sequence. Failure to follow this sequence may cause severe damage to the cover.

8. Install the structural cover.
9. Install the pinion bracket.
10. Install the left and right exhaust pipes.
11. Connect the left and right oxygen sensors.
12. Remove the engine lift plate.
13. Connect the knock sensors.
14. Connect the engine to body ground straps at the left side of the cowl.




15. Install the intake manifold using the sequence provided.
16. Install the engine oil dipstick tube.
17. Install the power brake booster vacuum hose.
18. Install the breather hoses.
19. Install the PCV hose.
20. Install the fuel rail.
21. Install the coil over plugs.




22. Connect the engine wiring harness at the following points:
- Intake air temperature (IAT) sensor (4)
- Fuel Injectors
- Throttle Position (TPS) Switch (2)
- Idle Air Control (IAC) Motor (3)
- Engine Oil Pressure Switch
- Engine Coolant Temperature (ECT) Sensor
- Manifold Absolute Pressure MAP) Sensor
- Camshaft Position (CMP) Sensor
- Coil Over Plugs
- Crankshaft Position Sensor





23. Connect the ground straps on the right (3)side of the engine.




24. Connect the ground straps on the left (2) side of the engine.




25. Reinstall the radiator/cooling module assembly.
26. Connect lower radiator hose.
27. Connect upper radiator hose.
28. Connect throttle and speed control cables.
29. Install the heater hose assembly.
30. Install coolant recovery bottle.
31. Install the power steering pump.
32. Install the generator (3).




33. Install the A/C compressor (2).
34. Install the drive belt.
35. Install the fan shroud with the viscous fan assembly.
36. Install the radiator core support bracket.
37. Recharge the A/C system [1][2]Capacity Specifications.
38. Install the air cleaner assembly.
39. Refill the engine cooling system.
40. Check and fill engine oil.
41. Connect the battery negative cable.
42. Start the engine and check for leaks.