Installation

LAMP





1. Check to be certain that the three front lamp unit U-nuts (5) and the plastic grommet (7) are in good condition and properly positioned on the front fender headlamp bracket (4).
2. Position the lamp close enough to the front fender to access and reconnect the two wire harness connections (6) to the headlamp bulb and the front park/turn signal/side marker bulb socket on the back of the lamp.
3. Rearrange the wire harnesses as necessary to prevent them from becoming pinched between the back of the lamp housing and the fender.
4. Align the ball stud (3) on the back of the upper outboard corner of the lamp with the grommet in the fender bracket.
5. Using hand pressure, press the lamp firmly and evenly rearward until the ball stud snaps into the grommet.
6. Install the three screws (3) that secure the inboard and lower mounts of the lamp to the U-nuts on the fender bracket. Tighten the screws in Tighten the screws in sequence beginning with the outboard lower, then the inboard upper and finally the inboard lower. Tighten the screws to 7 Nm (65 in. lbs.).
7. Reconnect the battery negative cable.
8. Confirm proper headlamp alignment. Procedures.