B1BA8

B1BA8-OCM SYSTEM OUT OF CALIBRATION/NOT CALIBRATED





- When Monitored:
While the CAN bus ignition status is IGN_RUN or signal not available.

- Set Condition:
This DTC will set if the Occupant Classification Module (OCM) has initiated a re-zero and did not successfully complete the system verification, a system verification routine has been aborted or a update option table from the flash routine has been completed.

1. PERFORM OCCUPANT CLASSIFICATION MODULE SYSTEM VERIFICATION TEST
1. Verify that the passenger seat is empty.

NOTE: Failure to follow the test instructions or aborting the test causes faults to set when performing the Occupant Classification Module System Verification Test. To prevent faults due to process errors: verify that all tests steps that led you here were performed as directed, verify that the ignition is in run. Wait 30 seconds after changing the seat weight before proceeding to allow the system to stabilize. Only press scan tool buttons when directed to do so and perform the Occupant Classification Module System Verification Test to completion. OCS Verification Test

2. With the scan tool in OCM, select More Options, System Tests and select Occupant Classification Module System Verification Test. Run the test by following the instructions displayed on the scan tool. When the test completes, wait two minutes and then proceed as follows.
3. With the scan tool, read the OCM DTC.

Does the scan tool display any other active DTCs?

Yes

- Diagnose and repair the active DTC. Testing and Inspection for a complete list of DTCs.

No

- Go To 2

2. VERIFY PASSENGER SEAT RISER, TRACKS AND STRUCTURE

WARNING: Turn the ignition off, disconnect the 12-volt battery and wait two minutes before proceeding. Failure to follow these instructions may result in possible serious or fatal injury.

1. Verify that the passenger seat is empty.

CAUTION: To avoid seat weight sensor damage, the Strain Gage Alignment Tool 9698A must be used to when loosening or tightening the sensor retainers.

2. Verify that all of the Seat Weight Sensor mounting screws are tightened to torque specification. [1][2]Restraints and Safety Systems.

WARNING: Turn the ignition on, then reconnect the 12-volt battery. Failure to follow these instructions may result in possible serious or fatal injury.

NOTE: Failure to follow the test instructions or aborting the test causes faults to set when performing the Occupant Classification Module System Verification Test. To prevent faults due to process errors: verify that all tests steps that led you here were performed as directed, verify that the ignition is in run. Wait 30 seconds after changing the seat weight before proceeding to allow the system to stabilize. Only press scan tool buttons when directed to do so and perform the Occupant Classification Module System Verification Test to completion. OCS Verification Test

3. With the scan tool in OCM, select More Options, System Tests and select Occupant Classification Module System Verification Test. Run the test by following the instructions displayed on the scan tool. When the test completes, wait two minutes and then proceed as follows.
4. With the scan tool, read the OCM DTC.

Does the scan tool display any other active DTC?

Yes

- Perform the DIAGNOSIS AND CHECKOUT PROCEDURE FOR SEAT WEIGHT SENSORS diagnostic procedure. . Diagnosis and Checkout Procedure for Seat Weight Sensors

Yes - Other DTC Present

- Diagnose and repair the active DTC. Testing and Inspection for a complete list of DTCs.

No Active DTC Present

- Perform the OCS VERIFICATION TEST. OCS Verification Test.