C2205

C2205-STEERING ANGLE SENSOR INTERNAL

For a complete wiring diagram, refer to the Wiring Information.

- When Monitored:
With ignition on, but not if supply voltage faults are detected.

- Set Condition:
If the Anti-Lock Brake System (ABS) Module detects that the Steering Angle Sensor sends an internal failure message.





CHECK FOR A DTC C2205-STEERING ANGLE SENSOR INTERNAL

NOTE: This DTC must be active for the results of this test to be valid.

1. Turn the ignition on.
2. With the scan tool, read and record DTCs.
3. With the scan tool, read and record Freeze Frame information.
4. With the scan tool, erase DTCs.

WARNING: Make sure brake capability is available before road testing.

5. Start the vehicle and turn the wheel from lock to lock.
6. Test drive the vehicle by turning the vehicle left or right in a curving manner at a velocity between 10 and 25 km/h (6 and 15 mph).
7. Park the vehicle.
8. With the scan tool, read and record DTCs.

Does the scan tool display: C2205-STEERING ANGLE SENSOR INTERNAL?

Yes

- Replace the Clockspring. The Steering Angle Sensor is internal to the Clockspring.
- Perform the ABS VERIFICATION TEST. ABS Verification Test.

No

- Perform the ABS INTERMITTENT CONDITION TEST. ABS Intermittent Condition Test.