Seat - Installation

INSTALLATION






WARNING: Before proceeding with the following repair procedure, review all warnings and cautions Service Precautions .

NOTE: Start all seat fasteners first before tightening to specifications.

1. Install the seats to the vehicle.
2. Slide the seats to the rearward position, connect the electrical connectors (5) and install the bolts (1).
3. Tighten the inboard bolts first then tighten the outboard bolts (1) to 62 Nm (46 ft. lbs.).
4. Install the seat belts (3) and bolts (2), Seat Belt Retractor - Installation.





5. Tighten the rear nuts (1) to 62 Nm (46 ft. lbs.).
6. Tighten the rear bolts (2) to 62 Nm (46 ft. lbs.).
7. Install the side shield (4) to the seats.
8. Install the head rest to the seats.
9. Do not reconnect the battery negative cable at this time. The supplemental restraint system verification test procedure should be performed following service of any supplemental restraint system component, . Supplemental Restraints Verification Test
10. Following successful completion of the supplemental restraint system verification test procedure, perform the Occupant Classification System Verification Test using a scan tool. OCS Verification Test Refer to the appropriate diagnostic procedures.