Tail Stop Turn Lamp - Installation

LAMP





1. Install two new plastic grommets (2) into the rear body sheet metal.
2. Position the rear lamp unit (4) to the lamp opening in the rear body sheet metal.
3. Reconnect the wire harness connector (1) to the connector receptacle on the socket plate on the back of the lamp housing.
4. Align the two ball studs on the outboard side of the rear lamp housing with the two plastic grommets in the rear body sheet metal.
5. Using hand pressure, push firmly and evenly on the outboard side of the lamp until the two ball studs snap into the plastic grommets.
6. Install the two plastic push-pin fasteners (3) that secure the inboard side of the lamp housing to the side jamb of the liftgate opening.
7. Reconnect the battery negative cable.