Side Repeater Lamp - Installation

LAMP

NOTE: Repeater lamps are used only on vehicles manufactured for certain markets where these lamps are required.





1. Position the repeater lamp lens/housing (3) close enough to the mounting hole in the fender (1) to access and reconnect the wire harness connector (2) to the bulb socket on the back of the lamp lens/housing.

NOTE: The same repeater lamp is used on both sides of the vehicle. Regardless of which side of the vehicle the lamp is on, when properly oriented the fixed hook tab integral to the back of the lamp housing is on the right-hand side of the lamp and the latch feature is on the left-hand side.

2. With the lamp lens/housing properly oriented, engage the hook tab on the back of the right side of the lamp with the right edge of the fender mounting hole.
3. Using hand pressure, press the left side of the lamp lens/housing into the mounting hole against the spring pressure of the latch feature until the latch snaps into place.
4. Reconnect the battery negative cable.