Side - B-Pillar

SIDE - B-PILLAR

WARNING: Disable the Supplemental Restraint System (SRS) before attempting any steering wheel, steering column, airbag, Occupant Classification System (OCS), seat belt tensioner, impact sensor or instrument panel component diagnosis or service. Disconnect and isolate the negative battery (ground) cable, then wait two minutes for the airbag system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the SRS. Failure to follow these instructions may result in accidental airbag deployment and possible serious or fatal injury.

WARNING: To avoid serious or fatal injury, never strike or drop the side impact sensor, as it can damage the impact sensor or affect its calibration. The side impact sensor enables the system to deploy the side Supplemental Restraint System (SRS) components. If an impact sensor is accidentally dropped during service, the sensor must be scrapped and replaced with a new unit. Failure to observe this warning could result in accidental, incomplete, or improper side SRS component deployment.

NOTE: The front and side impact sensors are interchangeable.





1. Reconnect the body wire harness connector (4) to the side impact sensor (3) connector receptacle.
2. Position the sensor onto the weld stud on the inner B-pillar (1). Be certain that the anti-rotation pin on the back of the sensor is engaged in the clearance hole of the B-pillar.
3. Install and tighten the nut (2) that secures the sensor to the weld stud on the inner B-pillar. Tighten the nut to 7 Nm (62 in. lbs.).
4. Reinstall the lower trim onto the inside of the B-pillar. B-Pillar Trim Panel-Installation.
5. Do not reconnect the battery negative cable at this time. The Supplemental Restraint System (SRS) verification test procedure should be performed following service of any SRS component. Service and Repair.