Operation CHARM: Car repair manuals for everyone.

No Response From CCN (Cluster)






NO RESPONSE FROM CCN (CLUSTER)












1. TEST FOR INTERMITTENT CONDITION
1. Turn the ignition on.

NOTE: Make sure the IOD fuse is installed and battery Voltage is between 10.0 and 16.0 Volts.

2. Using the scan tool, select ECU View.

NOTE: A red "X" will be next to the module that is not communicating, indicating that the module is not active on the Bus network. A green check indicates that the module is active on the Bus network.

Does the scan tool display a red "X" next to the module?

Yes

- Go To 2

No

- The no response condition is not present at this time. Using the wiring diagram/schematic as a guide, inspect the wiring for chafed, pierced, pinched and partially broken wires and the wiring harness connectors for broken, bent, pushed out and corroded terminals.

2. (A909) (A412) FUSED B(+) CIRCUIT OPEN OR SHORTED




1. Turn the ignition off.
2. Disconnect the Cluster C1 and C3 harness connectors.
3. Using a 12-volt test light connected to ground, check each (A909) and (A412) Fused B(+) circuit.

Does the test light illuminate brightly for each circuit?

Yes

- Go To 3

No

- Repair the Fused B(+) circuit for an open or short.
- Perform the BODY VERIFICATION TEST. Body Verification Test.

3. (Z911) GROUND CIRCUIT OPEN




1. Using a 12-volt test light connected to 12-volts, check each (Z911) ground circuit.

Does the test light illuminate brightly for each circuit?

Yes

- Go To 4

No

- Repair the (Z911) ground circuit for an open.
- Perform the BODY VERIFICATION TEST. Body Verification Test.

4. (F943) FUSED IGNITION RUN/START CONTROL OUTPUT CIRCUIT OPEN OR SHORTED




1. Turn the ignition on.
2. Using a 12-volt test light connected to ground, check the (F943) Fused Ignition Run/Start Control Output circuit.

Does the test light illuminate brightly?

Yes

- Go To 5

No

- Repair the (F943) Fused Ignition Run/Start Control Output circuit for an open or short.
- Perform the BODY VERIFICATION TEST. Body Verification Test.

5. (D265) OR (D264) CAN IHS BUS (125K) CIRCUIT OPEN




1. Measure the resistance of the (D264) CAN IHS Bus (-) (125K) circuit between the TIPM C7 harness connector and the Cluster C3 harness connector.
2. Measure the resistance of the (D265) CAN IHS Bus (+) (125K) circuit between the TIPM C7 harness connector and the Cluster C3 harness connector.

Is resistance below 5.0 Ohms on both circuits?

Yes

- Replace the Cluster.
- Perform the BODY VERIFICATION TEST. Body Verification Test.

No

- Repair the (D265) or (D264) CAN IHS Bus (125K) circuit for an open. Inspect the connector for damage.
- Perform the BODY VERIFICATION TEST. Body Verification Test.