Left Cylinder Head

LEFT CYLINDER HEAD





1. Disconnect the negative cable from the battery.
2. Raise the vehicle on a hoist.
3. Disconnect the exhaust pipe at the left side exhaust manifold.
4. Drain the engine coolant. Refer to COOLING SYSTEM.
5. Lower the vehicle.
6. Remove the intake manifold Intake Manifold - Removal.





7. Remove the master cylinder and booster assemblyPower Brake Booster - Removal.
8. Remove the cylinder head cover (1)Cylinder Head Cover(s) - Removal.










9. Remove the fan shroud and fan blade assembly.
10. Remove accessory drive belt.
11. Remove the power steering pump and set aside.
12. Rotate the crankshaft until the damper timing marks are aligned (2).










13. Verify the V8 mark on the camshaft sprocket is at the 12 o'clock position. Rotate the crankshaft one turn if necessary.
14. Remove the crankshaft damper Vibration Damper - Removal.
15. Remove the timing chain cover Engine Timing Cover(s) - Removal.





16. Lock the secondary timing chains to the idler sprocket using secondary camshaft chain holder 8429 (6).










NOTE: Mark the secondary timing chain prior to removal to aid in installation.

17. Mark the secondary timing chain, one link on each side of the V8 mark on the camshaft drive gear.
18. Remove the left side secondary chain tensioner Timing Chain & Sprockets - Removal.










CAUTION: Do not allow the engine to rotate. Severe damage to the valve train can occur.

19. Remove the cylinder head access plug (2).
20. Remove the left side secondary chain guide Timing Chain & Sprockets - Removal.
21. Remove the retaining bolt and the camshaft drive gear.






CAUTION: Do not overlook the four smaller bolts at the front of the cylinder head. Do not attempt to remove the cylinder head without removing these four bolts.

NOTE: The cylinder head is attached to the cylinder block with fourteen bolts.

22. Remove the cylinder head retaining bolts using the sequence provided.

CAUTION: Do not lay the cylinder head on its gasket sealing surface, due to the design of the cylinder head gasket any distortion to the cylinder head sealing surface may prevent the gasket from properly sealing resulting in leaks.

23. Remove the cylinder head and gasket. Discard the gasket.