Front Door Carrier Plate - Installation

INSTALLATION





1. Insert the latch (1) into the door and then tip the regulator rails into place through the door opening.
2. Make sure the lock knob is on the inboard side of the inner panel.





3. Align the three retaining clips (1) with the corresponding holes in the carrier plate and twist counter clockwise to seat fully.





4. Install the screws (3) and tighten to 6 Nm (53 in. lbs.).





5. Install the actuator links (1, 2) onto the front door latch (4) and engage the retainers.
6. Install the three screws (3) that secure the front door latch to the door. Tighten the screws to 7 Nm (62 in. lbs.).




7. Position the wire harness back and connect the electrical connectors.
8. Connect the passive entry jumper harness connector (1). Make sure the wire is routed correctly in the trough in the carrier plate and close the access panel.
9. Install the front door glass. Front Door Glass - Installation