Front

INSTALLATION

NOTE: Take the proper precautions to protect the face of the A/C-heater control, center bezel and the instrument panel switch pod from cosmetic damage while performing this procedure.





1. Position the A/C-heater control (2) into the instrument panel center bezel (3).
2. Install the four screws (1 and 4) that secure the A/C-heater control to the center bezel. Tighten the screws to 2 Nm (17 in. lbs.).
3. Install the instrument panel center bezel Instrument Panel Bezel - Installation.
4. Reconnect the negative battery cable.
5. Initiate the Actuator Calibration function using a scan tool Testing and Inspection.
6. If equipped with rear heating-A/C system, calibrate the rear A/C-heater control as follows:
- Verify that the Actuator Calibration of the front A/C-heater control has passed. Correct any errors before proceeding if the Actuator Calibration has not passed.
- Rotate the rear temperature control knob counter clockwise to the full cold position. Allow the control to remain in the full cold position for 5 seconds.
- Rotate the rear temperature control knob clockwise to the full hot position. Allow the control to remain in the full hot position for 5 seconds.
- Calibration is now complete. Verify proper front and rear heating-A/C system operation.