Installation

INSTALLATION

NOTE: If equipped with adjustable pedals: When replacing the components both pedal assemblies must be in the fully down position toward the floor for proper adjustment. Pedals can be moved manually by rotating the cable on the component not being replaced. New components come in the correct position until activated.





1. Position the accelerator subassembly (6) and install the rear mounting screw (4).





2. Install the accelerator subassembly front mounting nut (3).






NOTE: Drive cable to motor housing adapter (2) can be turned manually within the motor housing (1) to allow proper alignment for drive cable attachment to motor.

3. Verify the drive cable to motor housing adapter (2) is properly inserted in motor housing (1) before attaching drive cable.






NOTE: A snap sound should be heard when drive cable locks into position.

4. Align drive cable housing to motor tabs/slots (3), and using light hand pressure push drive cable (2) into position on the drive motor (5). Turn counter clockwise to lock into position.
5. Install the pedal assembly, Brake and/or Accelerator Pedals - Installation