C.In-Tank Fuel Pump Installation

C. In-Tank Fuel Pump Installation

1. Remove the fuel tank gauge sending unit per service manual procedure and discard.

2. Install the new seal, PN 6031475, and new gauge/pump unit, PN 4075447, per the service manual procedure. Use extreme caution to protect the float and gauge assembly during installation into the fuel tank.

3. Attach the red mold of body wiring harness, PN 4331719, onto the red stud on newly installed gauge/pump unit, PN 4075447. Reinstall dark blue wire of original wire harness onto black stud on gauge/pump assembly, and gray wire onto ground blade.

CAUTION: INCORRECT WIRING CONNECTIONS WILL CAUSE THE FUEL LEVEL GAUGE INDICATOR TO FAIL AND TIME ELECTRIC FUEL PUMP TO BE INOPERATIVE.

NOTE: SET ASIDE THE REST OF BODY HARNESS, PN 4331719, TO ASSURE HARNESS WILL NOT BE PINCHED WHEN RAISING FUEL TANK INTO POSITION.

4. Reinstall fuel tank per the service manual procedure.