B.Instrument Panel Harness Pn 4331718

INSTRUMENT PANEL WIRING:

FIGURE 5:

B. Instrument Panel Harness PN 4331718

1. Remove instrument panel steering column cover.

2. Insert two bare terminals from instrument panel overlay harness, PN 4331718, into the vacant cavities of the instrument panel side of the bulkhead connector as shown in Figure 2-A and outlined below.

a. Gray with black tracer wire into cavity #39 (cavity #27 for 1981 model year vehicles only).
b. Dark green wire into cavity #23.

3. Disconnect the 5-way ignition switch connector and remove the yellow wire (Figure 2-B). Install the yellow wire just removed into the top half of the natural colored 2-way female connector supplied with the instrument panel overlay harness, PN 4331718.

NOTE: YELLOW WIRE IN FEMALE CONNECTOR SHOULD LINE UP WITH YELLOW WIRE IN MALE CONNECTOR OF OVERLAY HARNESS, PN 4331718 (FIGURES 2-B AND 5).

Install the bare terminal yellow wire of the instrument panel overlay harness, PN 4331718, into the previously vacated cavity in the ignition switch connector (Figures 2-B and 5).
4. Remove the dark blue wire from the 5-way ignition switch connector and install into the bottom half of the natural colored 2-way female connector of overlay harness (opposite the dark blue wire in male half of overlay harness, PN 4331718). Install the bare terminal dark blue wire from overlay harness into previously vacated cavity in ignition switch connector (Figures 2-B and 5).

5. Reconnect the natural colored 2-way connectors supplied with the instrument panel overlay harness and reconnect the ignition switch connector.

6. Secure bare eyelet ground terminal (black wire) from instrument panel overlay harness to the existing instrument panel ground, located at the left side cowl (Figure 2-D). Torque screw to 65 inch pounds.

7. Connect the control (auto shut down) module, PN 5226640, to the white colored 8-way connector from the instrument panel overlay harness. Fasten module to main instrument panel wiring harness with tie wrap, PN 6015756, as illustrated in Figure 2-C. Keep instrument panel harness and module clear of any possible interferences.

FIGURE 2-EINSTRUMENT PANEL WIRING:

8. Route instrument panel harness and secure by spot taping as shown in Figure 2-E.