F.Fuel Pressure Regulator Package Installation

3. For all models except 1981-1984 equipped vith Carter thermoquad 4BBL carburetor:

Connect the battery terminal. Check wire and hose routing, start the engine, and inspect the entire system for fuel leaks.

F. 1981 Through 1984 Models Equipped With Carter Thermoquad 4BBL Carburetor Only - Fuel Pressure Regulator Package Installation (PN 4397656)

1. Remove the original carburetor inlet fuel tube and discard.

FIGURE - 4FUEL PRESSURE REGULATOR INSTALLATION:

2. Fasten the bracket, PN 4418010, to the fuel pressure regulator, PN 4418009, using the two (2) self-tapping screws supplied, PN 6033066 (Figure 4).

NOTE: BE SURE THAT OUTLET SIDE OF REGULATOR FACES THE CARBURETOR INLET.

3. At the tapped boss on the right side of the intake manifold, install bracket and fuel pressure regulator assembly using the screw and washer, PN 6022254 (Figure 4).

NOTE: IF THERE EXISTS AN A/C ALTERNATOR BRACKET SUPPORT STRUT IN THIS LOCATION, THEN LOOSEN THE OPPOSITE END OF THE STRUT FIRST. REMOVE AND DISCARD THE SCREW AND WASHER HOLDING THE STRUT TO THE MANIFOLD. SLIDE REGULATOR BRACKET UNDER THE SUPPORT STRUT AND SECURE WITH SUPPLIED SCREW AND WASHER, PN 6022254, THEN TIGHTEN THE OPPOSITE END OF THE STRUT.
CAUTION: BE EXTREMELY CAREFUL NOT TO DAMAGE OR PINCH ANY HARNESS IN THE AREA.

4. Install new tube, PN 4418008, from the regulator outlet to the carburetor inlet. Install new tube, PN 4418007, from the filter outlet hose to the regulator inlet (Figure 4). Be sure that the tube passes through the clip mounted on the mechanical fuel pump attachment bolt. Slightly compress clip to secure tube away from any possible interference to nearby components.

5. Install clamp, PN 6500651, as shown in Figure 4 (filter outlet hose to regulator inlet tube). Rotate clamp so that it is not in contact with any other surface.

6. Reconnect the battery terminal. Check wire and hose routing, start the engine, and inspect the entire system for fuel leaks.
POLICY: Reimbursable within the provisions of the warranty


TIME ALLOWANCE:
Labor Operation No. 14-70-17-92 - ALL 1.7 Hrs.
Add with Carter Thermoquad - 14-70-17-50 0.4 Hrs.


FAILURE CODE: AM - Authorized Modification