Seat Belt Motor: Service and Repair

Fig. 152 Motor & Cable Assembly:

Fig. 153 Track Assembly:

REMOVAL

1. Remove necessary trim panels to access track and motor.
2. Disconnect electrical connector.
3. Remove drive motor attaching nut, then the cable retaining screws.
4. Remove track attaching screws.
5. Remove lock box attaching screws, then motor and track assembly.

INSTALLATION

1. Install motor and track assembly, then align rail holes with body holes and install a Christmas tree fastener at the mid point of the rail.
2. Install the motor assembly to the body.
3. Install the drive motor nut and torque to 10 lb-ft.
4. Connect electrical connectors, then install and finger tighten the two lock box screws.
5. Install the rearward rail attaching screw and torque to 35 lb-in.
6. Torque lock box screws to 12 lb-ft.
7. Install the forward track screws and torque to 35 lb-in.
8. Install the remaining two track screws and torque to 35 lb-in.
9. Install drive cable retaining clips.
10. Install trim panels.