Rear Seat Cushion

REAR SEAT CUSHION

REMOVAL - REAR

NOTE: Fabric covered cushions are serviced as an assembly.

Fig. 27:

1. Pull upward at forward edge of cushion each retainer loop of the rear seat cushion to disengage retainer loops from cups in floor (Fig. 27).
2. Guild seat belts through loops.
3. Remove rear seat cushion from vehicle.

REMOVAL - JR-27 (Convertible) ONLY

NOTE: Special care should be taken when removing rear seat cushion to prevent damage to the cushion frame. Remove cushion at attachment areas, not at wing area.

Fig. 28:

1. Push firmly rearward and upward at one attachment point and disengage wire loops from retainers in floor pan (Fig. 28).
2. Repeat for other attachment point.
3. Separate rear seat cushion from vehicle.

INSTALLATION - REAR

NOTE:
- Fabric covered cushions are serviced as an assembly.
- Verify visibility of "Latch" bars in the seat bite area.

1. Place rear seat cushion in position.
2. Guild seat belts through loops.
3. Engage retainer loops into cup on floor kick-up.
4. Push downward at forward edge at each retainer loop of the rear seat cushion to engage retainers.

INSTALLATION - JR-27 (Convertible) ONLY

NOTE: Special care should be taken when removing rear seat cushion to prevent damage to the cushion frame. Remove cushion at attachment areas, not at wing area.

1. Position rear seat cushion in vehicle.
2. Place inner seat belts on top of seat cushion.
3. Push seat cushion rearward and align wire loops to retainers in floor pan.
4. Push rear seat cushion firmly downward and engage wire loops to retainers in floor pan.