Right Lower Instrument Panel Trim

RIGHT LOWER INSTRUMENT PANEL TRIM

REMOVAL

1. Disconnect and isolate the battery negative remote cable.
2. Remove one screw to shift knob and transmission range indicator bezel from floor console.
3. Remove floor console.
4. Remove instrument panel kick shield. Refer to Knee Diverter.
5. Remove right and left instrument panel end cover.
6. Remove left lower instrument panel trim.
7. Remove instrument panel center bezel.
8. Remove instrument panel inboard bezel and outboard bezel.
9. Remove right instrument panel trim bezel.
10. Remove instrument panel cluster bezel.
11. Remove CD changer Trim Bezel, CD player, and CD support bracket (if equipped).
12. Remove radio.
13. Unsnap right a/c barrel and remove a/c housing.
14. Remove glove box.
15. Remove 13 screws and remove panel.
16. Remove cubby bin mat (if equipped).

INSTALLATION

1. Install new right lower trim panel onto instrument panel beam assembly.
2. Attach five screws around glove box opening. Note the lower right hand screw must be installed first to properly align glove box door.
3. Attach one screw on right outboard end.
4. Attach two screws above glove box door opening.
5. Attach two screws below radio opening.
6. Attach three screws along left end of panel.
7. Install glove box assembly.
8. Install right a/c housing and attach with three screws. Note the two upper screw attachments use the pan head screws and the bottom attachment uses the hex head screw.
9. Attach right a/c barrel.
10. Install radio and attach.
11. Install CD bracket, CD player, and CD trim bezel (if so equipped).
12. Install instrument panel cluster bezel.
13. Install outboard, inboard, and right trim bezels.
14. Install center bezel.
15. Install left lower instrument panel trim.
16. Install right and left instrument panel end covers.
17. Install instrument panel kick shield.
18. Install console assembly.
19. Reconnect battery.