B1 Clutch - Disassembly

DISASSEMBLY

Special Tools:















1. Remove the teflon rings (1)(Figure 1) from the B1 plate carrier hub (2).




Figure 2 - Holding Clutch B1





2. Remove snap-ring (7)(Figure 2).
3. Remove multiple-disc pack (6) and disc spring (5) from outer multiple-disc carrier. Note which clutch disc is removed just prior to the disc spring (5) for re-assembly. If the clutch discs are re-used, this disc must be returned to its original position on top of the disc spring.
4. Place the Multi-use Spring Compressor (8)(Figure 2) on disc spring (3) and compress the spring until the snap-ring (4) is exposed.
5. Remove snap-ring (4).
6. Remove piston (2) from the outer multiple-disc carrier by carefully blowing compressed air into the bore (A).