Upper Front Lamp Unit - Installation

LAMP

NOTE: The upper front combination lamp unit combines the low beam headlamp bulb and the turn signal lamp bulb in a single lamp unit. This lamp is used only on vehicles manufactured for sale in Mexico and Latin America and replaces the headlamp unit used on vehicles manufactured for sale in the United States and Canada.





1. Position the upper front combination lamp unit (2) close enough to the front of the vehicle to reconnect the wire harness connector to the receptacle on the back of the lamp housing.
2. Position the upper front combination lamp unit (2) onto the front fender and Front End Module (FEM) support structure.
3. Install and tighten the three screws (1) that secure the upper front combination lamp unit to the vehicle. Tighten the screws to 10 Nm (89 in. lbs.).
4. Reinstall the fascia onto the front of the vehicle. Front Bumper Fascia - Installation.
5. Reconnect the battery negative cable.
6. Confirm proper headlamp alignment. Adjustments.