Upper Front Lamp Unit - Removal

LAMP

NOTE: The upper front combination lamp unit combines the low beam headlamp bulb and the turn signal lamp bulb in a single lamp unit. This lamp is used only on vehicles manufactured for sale in Mexico and Latin America and replaces the headlamp unit used on vehicles manufactured for sale in the United States and Canada.





1. Disconnect and isolate the battery negative cable.
2. Remove the fascia from the front of the vehicle. Front Bumper Fascia - Removal.
3. Remove the three screws (1) that secure the upper front combination lamp unit (2) to the front fender and the Front End Module (FEM) support structure.
4. Pull the upper front combination lamp unit away from the front of the vehicle far enough to access the wiring connection on the back of the lamp housing.
5. Disconnect the wire harness connector from the upper front combination lamp unit connector receptacle.
6. Remove the upper front combination lamp unit from the vehicle.