Installation

INSTALLATION






NOTE: This sensor monitors both Inlet Air Temperature (IAT) and Manifold Air Pressure (MAP).

1. The IAT/MAP sensor O-ring (1) can be reused if not damaged.
2. Apply a small amount of engine oil to the sensor O-ring (1).





3. Install the IAT/MAP sensor (1) into the intake manifold with the bolt (2) tightened to 9 Nm (80 in. lbs.).
4. Connect and lock the electrical connector (3) to the sensor.





5. Install the air cleaner body (6) Air Cleaner Body - Installation.





6. Install the engine cover (1).
7. Connect the negative battery cable and tighten nut to 5 Nm (45 in. lbs.).