Installation

1. Install bearing assembly into bearing bore of right hand trunnion, with bearing name and part number facing outward towards installing Tool T8OT-4000-N or equivalent. The tool will stop against housing when bearing is seated to proper depth.

2. Apply a light coat of grease on the lip of the seal and assembly into trunnion of the carrier.

3. Install slip yoke/shaft assembly into carrier and through side gear spline exposing snap ring groove inside differential.

4. Place the snap ring in the groove. Force the snap ring into place using two screwdrivers or other suitable tools.

5. Hold shaft and joint assembly in a heavy duty vise. Install a new spindle seal on outboard yoke shaft.