Section A Has Been Superseded By TSB # 9264, Dated 3/92.

CAUTION: FAILURE TO THOROUGHLY RINSE THIS SURFACE COULD RESULT IN CORROSION OF ANODIZED ALUMINUM OR STAINLESS STEEL PARTS

PROCEDURE # 2

FINISH KARE FORMULA # 1119 AND # 883 (Buffered solution not as harsh on aluminum parts)

WARNING: FOR YOUR SAFETY, USE RUBBER GLOVES, GOGGLES AND PROTECTIVE CLOTHING WHEN HANDLING THESE PRODUCTS.

1. Apply hot diluted solution with soft mitt.

2. Agitate to create suds. Suds hold the acid solution in suspension and to the surface creating greater and extended activity.

3. Allow 3 to 5 minutes dwell time.

4. Rinse with COLD WATER.

5. Apply # 883 per label instructions.

LIQUID NEUTRALIZER CONCENTRATE

1. Using a mitt, thoroughly go over the entire surface with the diluted solution (50-1) of water and # 118 Liquid Neutralizer Concentrate. Then wipe dry.

2. If the iron particles are not totally removed after 2 washings, use one or both of the following service actions.

a. Sand with micro fine sandpaper (1500 Grid or greater) in localized areas.

b. Buff with very light compound and polish with wax in localized areas.

WARNING: OUR ENVIRONMENT IS PRECIOUS - PLEASE USE PROPER DISPOSAL TECHNIQUES FOR ANY VOLATILE ORGANIC COMPOUNDS (V.O.C.'S) OR EXCESS MATERIALS.