Power-LOC Differential

1. Scribe a mark between the differential case halves to be used during assembly. Also, mark the pinion mate shafts and corresponding ramps for assembly in original locations.
2. Clamp differential assembly in a soft jaw vise.

Fig.17 Powr-Lok Locking Differential:

3. Loosen but do not remove the case half retaining bolts, Fig. 17.
4. Place assembly on bench with the ring gear half down and remove case half retaining screws.
5. Remove the cover half of the case.
6. Remove upper mate shaft, side gear, side gear ring and clutch pack. Retain parts with cover half of case so they can be installed in original position.
7. Remove lower mate shaft, side gear, side gear ring and clutch pack from drive gear case half.