Disc Brake System

Item Part Number Description

1 N807794-S60 Bolt, M16-2.0 x 50
2 N601797-S2 Bolt, Caliper Mount M12-1.75 x 30
3 2C150 Pin, Caliper Slide
4 2C357 Disc Brake Caliper
5 2B292 Anchor Bracket
6 2K005 Front Disc Brake Rotor Shield
7 N611172-S2 Screw, Self Tapping, M6-1.0 x 12
(4 Req'd)
8 1190 Wheel Hub Grease Seal
9 1216 Differential Bearing, Outer
10 N642569-S36 Cotter Pin
11 1131 Hub Grease Cap
12 390622-S Nut Retainer
13 374504-S100 Nut, Spindle
14 1195 Front Wheel Outer Bearing Retainer
Washer
15 1102 Hub and Rotor Assembly
16 4421 Differential Bearing, Inner
17 2B160 Gasket, Brake Spindle to Shield
18 2B164 Disc Brake Anti-Rattle Clip
19 3105 Front Wheel Spindle
20 1012 Lug Nut
A -- Tighten to 7-10 N-m
(5-7 Lb-Ft)
B -- Tighten to 191-259 N-m
(141-191 Lb-Ft)
C -- Tighten to 30-36 N-m
(22-26 Lb-Ft)
D -- Tighten Nut 374504-S100 to 23-34 N-m
(17-25 Lb-Ft) while rotating rotor.
Back off nut 120-180°. Use torque
wrench set to tighten nut 2.49-2.82
N-m (22-25 Lb-In). End play to be
0.006-0.127 mm (.00025-.005 in.).
Position nut retainer 390622-S over
nut so that a slot in the retainer
lines up with the cotter pin hole in
the spindle. The adjusting nut must
not be rotated while installing
retainer. Insert cotter pin and
secure by bending the legs in
opposite directions around the nut
retainer.